This station is blocked now for 20 minutes. If you don’t get a response from the dx station after three transmissions, RUMlog cancels this attempt. You should disable the option wkd b4 in the DX-Spot window to prevent calling the same station again and again. Since this option is active for new ones only, you have to configure your DX-Alarms in the Preferences. Attention: The transceiver can go to the transmit state now without any further user action! The Auto option will be disabled, when is band is changed. To activate this feature, check the box Auto in the Network window. Information from the dx-spot window will be used. This feature isn’t designed for a full automatically operation, it’s just an operational help to react very quickly on short band openings. RUMlog can command WSJT-X to answer cq calls in FT8 mode. The trx will be set to the mode, you have selected for PSK operation. You can use the frequency popup menu in WSJT-X to command RUMlog to QSY the trx. To use the CAT functions, you transceiver has to be connected with RUMlog. When this option is set, only cq calls will be listed in the dx-spot window. Similar to the double click function in WSJT-X you can change the behaviors of it holding down the Shift or the Option (Command key in WSJT-X) key. When the spot is a cq call from WSJT-X, you can double click on the frequency to activate this station in WSJT-X. “CQ DX DL2RUM” will fail, correct is: “CQ DL2RUM DX”. This works only correct, when the correct sequence is used. WSJT-X version 1.9 RC4 or newer required! Dx-spot tableĪ ‘?’ in front of a message indicates that the decode has a higher than normal probability of being false.ĭecoded messages from WSJT-X can be shown in the dx-spot window.
0 Comments
Leave a Reply. |